2 posts / 0 new
Last post
Kostakis
Offline
Last seen: 2 years 7 months ago
Joined: 2015-01-20 16:15
DA14580 programming

Hi. I am designing my first da14580 board and i have some questions about the programming interface. I read the "End product testing and programming guidelines" document but i still can't find out how to connect my board with pc in order to program da14580. Could i use jlink debugger as a "Interface Board" in order to program da154580 on my board? Is there any available schematic about how to make the programming required connections between da14580 and pc? Thank you!

HL_Dialog
Offline
Last seen: 3 years 2 months ago
Staff
Joined: 2013-12-17 03:04
Hi Kostakis,

Hi Kostakis,

Yes, you can use Jlink debugger to download firmware into DA14580.
3.3V /GND / SWCLK/SDIO is needed and if OTP programming is needed, 6.7V power supply is also needed @VPP pin for OTP burning.

and PC console smartsnippets (Dialog software)can facilitate your the programming procedure .

HL_Dialog