DA14580DEVKT-BUserGuide - selecting options

7 posts / 0 new
Last post
mazhar897
Offline
Last seen: 7 years 1 month ago
Joined: 2015-07-24 22:52
DA14580DEVKT-BUserGuide - selecting options

I have used this document DA14580DEVKT-BUserGuide. However, I cannot enter an option when the window showing u- UART f-SPI etc. occurs

Device: 
MT_dialog
Offline
Last seen: 1 year 9 months ago
Staff
Joined: 2015-06-08 11:34
Hi mazhar897,

Hi mazhar897,

Can you give me the document code from the manual you are trying to use, i cant undestand which document you mean. I suppose that UM-B-048 is the one but i can not figure out the options you are talking about.

Thanks MT_dialog

mazhar897
Offline
Last seen: 7 years 1 month ago
Joined: 2015-07-24 22:52
this is the code I am trying

this is the code I am trying to run - DA14580_peripheral_setup.

MT_dialog
Offline
Last seen: 1 year 9 months ago
Staff
Joined: 2015-06-08 11:34
Hi mazhar897,

Hi mazhar897,

Do you have your software correctly configured for operating with the SPI and the UART? And also you have to rearrange your jumper settings and connect the GPIO_PIN_7 with the T_TxD pin. And also can you please check with an FTDI chip connected to the pins of the da and not use the the FTDI of the Basic Kit.

Thanks MT_dialog

mazhar897
Offline
Last seen: 7 years 1 month ago
Joined: 2015-07-24 22:52
It works if I connect GPIO

It works if I connect GPIO_PIN_7 with the T_TxD pin. Am I suppose to follow figure 6 from the document or just one connection is good? If it is, can you please explain why so?

MT_dialog
Offline
Last seen: 1 year 9 months ago
Staff
Joined: 2015-06-08 11:34
Hi mazhar897,

Hi mazhar897,

If you check the code the pin P0_7 is set as the Rx so you have to connect it to the specified Tx pin of the FTDI module. With the default jumper settings you are connecting the P0_7 pin with the RTS of the FTDI.

Thanks MT_dialog

mazhar897
Offline
Last seen: 7 years 1 month ago
Joined: 2015-07-24 22:52
Thanks

Thanks

Topic locked