I cannot find the wat to search topics by subject. I assume there is one sorry but I don't see the search bar.
The link for this does not allow for uploading the design file and
does not give the quantity pricing or minimum.
Is the minimum 500 or 3000?
Hi, we are using DA14580 with CodeLess DA14580 v_5.3184.108.40.206. If we restart the module bonding got lost so user needs to rebond to the BLE module on each restart. What can we do to store the bonding information so it wont be got lost on each restart?
I intend to use SLG46826V to design a CLK buffer to generate 25MHz waveform with 50% duty circle
however, the output seems not what I' expecting.
Attached is the design with waveforms.
Could you please advise?
Bluetooth is a short-range wireless communication technology standard. Bluetooth is managed by the Bluetooth Special Interest Group (SIG), which has more than 35,000 member companies in the areas of telecommunication, computing, networking, and consumer electronics. The IEEE standardized Bluetooth as IEEE 802.15.1, but no longer maintains the standard. The Bluetooth SIG oversees development of the specification, manages the qualification program, and protects the trademarks
is there a "language" that can be used to design this device (HDL?)?
the graphical interface is not very friendly, specially adding wires..
const static sleep_state_t app_default_sleep_mode = ARCH_EXT_SLEEP_ON;
2.现在我在DSPS工程中设置变量app_default_sleep_mode =ARCH_SLEEP_OFF；关闭睡眠模式的情况下，我该如何手动设置DA14583让其进入extended sleep？
I try to program a SLG46826 soldered on our custom board. I connected GND, SDA, SCL and VDD from the In-System programmer to the SLG46826 and selected the programmer board in the GreenPAK Designer.
I can read out the device information using the "Read" button.
When I press the "Program" button, the blue LED of the In-System board blinks for a few seconds and then the following message is displayed:
Programming was done with error. Programming sequence doesn't match to the read sequence.
I'm looking for the STM32 firmware of the DA9070 evaluation board or anything else that can help me build my own firmware.
I have downloaded the example file and have a list of errors, has anyone else tried and succeeded to get this project at
working?, or can explain what the errors mean?