Learn MoreFAQsTutorials

4 posts / 0 new
Last post
benyeats
Offline
Last seen: 1 year 5 months ago
Joined: 2018-11-22 16:28
14583 programming using SWD

Is it possible to programme the DA14583 internal FLASH using the SWD interface?

I have my custom PCB connected to the PRO Dev board with the following connections:

- SWD
- GND
- VCC
- SWCLK

I can load my programme and run it from RAM no problem

Ben

Device: 
PM_Dialog
Offline
Last seen: 20 hours 38 min ago
Staff
Joined: 2018-02-08 11:03
Hi benyeats,

Hi benyeats,

In fact that you have a custom board, you can download firmware to the internal SPI Flash of the Da14583 with the usage of the Smart Snippets toolbox. This can be done either via UART or the JTAG interface.

I would highly suggest you have a look at the FAQs, in the Development kits & reference designs section, there is a question "How to program a custom board using a development kit (basic or pro)". Here you can find all the necessary connection should be done.

https://support.dialog-semiconductor.com/guide/faq-dev-kits-ref-designs

Could you please let me know if you have the Smart Snippets toolbox downloaded from Dialog support portal?

Thanks, PM_Dialog

benyeats
Offline
Last seen: 1 year 5 months ago
Joined: 2018-11-22 16:28
Problem now fixed, missing a

Problem now fixed, missing a bit of wire!

PM_Dialog
Offline
Last seen: 20 hours 38 min ago
Staff
Joined: 2018-02-08 11:03
Hi benyeats,

Hi benyeats,

Glad that you figured your issue out. If you found the answer helpful, please mark it as accepted.

Thanks, PM_Dialog