3 posts / 0 new
Last post
Zhangkui
Offline
Last seen: 5 months 3 weeks ago
Joined: 2014-12-31 07:20
Da14583 RF output abnormal

Hi Dialog:

I purchased 5000 pieces of da14583 from Avnet for production. After welding, it was found that about 10% of the boards had no Bluetooth broadcasting signal output. The faulty boards could download and run firmware normally, but there was no radio frequency signal output. Through the oscilloscope, we could see the strange waveform shown by the attachment at the foot of the RFIOP, while the normal working boards had no such signal output. Reverse the da14583 on the normal and abnormal working boards, you can find that the problem is caused by da14583.

This problem occurs after the program has been burned down, not after a period of time.           

Using routines in SDK, such as prox_reporter, is the same phenomenon.           

Why does this happen? Looking forward to your reply, thank you!

 

Thanks

Zhangkui

 

Attachment: 
Device: 
PM_Dialog
Offline
Last seen: 8 hours 7 min ago
Staff
Joined: 2018-02-08 11:03
Hi Zhangkui,

Hi Zhangkui,

Thanks for your question. Someone of the team will reach out directly.

Regards, PM_Dialog

Zhangkui
Offline
Last seen: 5 months 3 weeks ago
Joined: 2014-12-31 07:20
Hi PM_Dialog,

Hi PM_Dialog,

Thanks for your reply, my email mailbox is kui.zhang@ecordum.cn, please let me know if you need any information from me.

Best regards,

Zhangkui