Learn MoreFAQsTutorials

6 posts / 0 new
Last post
rajesh kaliyaperumal
Offline
Last seen: 6 days 16 hours ago
Joined: 2020-07-14 14:14
Module PCB Layout

Hi Team,

Regarding the Layout constraints for the module, We have mouting holes in PCB near the module & for that we are planning to use nylon screws instead of metal screws.

Due to space constraint & Reliable mounting of PCB , we cannot have cutout in PCB where antenna of the module resides. But we are making sure no copper is around that area.

Kindly give your comment on it.

Attached the mouting hole location & Module location in the PCB for your reference....

Regards,

Rajesh

Attachment: 
rajesh kaliyaperumal
Offline
Last seen: 6 days 16 hours ago
Joined: 2020-07-14 14:14
Hi Dialog Team,

Hi Dialog Team,

Could you reply on the query  ? Is having 2.6mm Clearance from a metal screw from PCB antenna area okay ? 

Attached the layout Pdf for your reference.

Appreciate your reply at the earliest.

Regards,

Rajesh K

PM_Dialog
Offline
Last seen: 2 days 6 hours ago
Staff
Joined: 2018-02-08 11:03
Dear Rajesh,

Dear Rajesh,

Many thanks for your question and for your interest in our BLE solutions. Apologies for the big delay, but you have posted your question on our Chinse forums and customer are posing in Chinese language.

https://support.dialog-semiconductor.com/forums/dialog-smartbond-bluetooth-low-energy-%E2%80%93-hardware-device-reference-designs

To do so, please let me move your question on our English forums - I will check your queries in detailed and I’ll get back to you as soon as possible.

Thanks, PM_Dialog

PM_Dialog
Offline
Last seen: 2 days 6 hours ago
Staff
Joined: 2018-02-08 11:03
Hi Rajesh,

Hi Rajesh,

Please see section 8 Design Guidelines from the DA14531 Module Datasheet. Metals close to the antenna will degrade the antenna’s performance. The amount of degradation depends on the host system’s characteristics.

Thanks, PM_Dialog

rajesh kaliyaperumal
Offline
Last seen: 6 days 16 hours ago
Joined: 2020-07-14 14:14
Thanks for the support!...We

Thanks for the support!...We have managed in layout to meet the guidelines...

PM_Dialog
Offline
Last seen: 2 days 6 hours ago
Staff
Joined: 2018-02-08 11:03
Hi Rajesh,

Hi Rajesh,

Thanks for accepting my answer. If you have any other follow up question, please raise a new post on our public EN forums.

Thanks, PM_Dialog