DA7212 in DSP mode

2 posts / 0 new
Last post
gvellet
Offline
Last seen: 2 months 3 weeks ago
Joined: 2019-03-15 19:17
DA7212 in DSP mode

Hi 

I have the DA7212-EVAL board. I wish to test the DSP mode capability of the codec as stated in the datasheet page 57. This is to verify the concept of my project which is going to use four DA7212 device connected to a DSP from Texas Instrument OMAP-L138.

From what I understand, the eval board uses a microcontroller SAM3U to interface with the codec DAI. From your application Smartcanevas, I cannot modify the behavior of the SAM3U; it seems to default in I2S master mode.

With the eval board, is there a possibility to test the DSP mode of the CODEC DAI?

If not, can you provide the source code of the SAM3U firmware available so I could set it up in DSP mode?

Best regards,

G Vellet

Device: 
ED_Dialog
Offline
Last seen: 1 day 7 hours ago
Staff
Joined: 2017-09-18 11:54
Hello,

Hello,

Let me check with the application team to see if the software is in a shareable format.

Kind regards,
Elliott