DA9062 evaluation board , problems programming the device

4 posts / 0 new
Last post
massimo.bertoli...
Offline
Last seen: 6 months 2 weeks ago
Joined: 2016-10-25 13:02
DA9062 evaluation board , problems programming the device
Attachment: 
Device: 
ED_Dialog
Offline
Last seen: 13 hours 24 min ago
Staff
Joined: 2017-09-18 11:54
Hello Massimo,

Hello Massimo,

  • Who is the customer?
  • Does the Eval board start-up ok in powercommander mode?
  • Is the customer able to commuicate with the board in powercommander mode?
  • Which varaint did the customer start off with?
  • Does the eval board have the correct jumpers installed? 
  • Do they have -00 parts or preprogrammed parts?
  • What input voltage is the customer using?
  • What is the current limit set on the bench supply?

 

Do you have any further information on this project?

 

Kind regards,

Elliott Dexter

ED_Dialog
Offline
Last seen: 13 hours 24 min ago
Staff
Joined: 2017-09-18 11:54
Hello Massimo,

Hello Massimo,

 

I have checked the ini file you provided. The ini file is in bad state. It would appear that the ini file has had certain registers cleared that are essential for it to operate correctly. I would suggest starting the ini file again from a trusted dialog ini file. Some of the register that have been changed could not have been changed via the GUI, so how some of these register have been altered is interesting, one method would have been to edit the ini file directly and not through the GUI. We do not recommend editing the file this way.

My suggestion would be to start the ini file again and to only edit the ini file through the GUI.

If you need assistance with the ini file then let me know.

 

Kind regards,
Elliott Dexter  

 

 

ED_Dialog
Offline
Last seen: 13 hours 24 min ago
Staff
Joined: 2017-09-18 11:54
This issue was handled

This issue was handled directly.

Topic locked