DA9062 - nONKEY timing

Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at https://www.dialog-semiconductor.com/support . We’ll be fixing bugs / optimising the searching and tagging over the coming days.
5 posts / 0 new
Last post
mmittelberger
Offline
Last seen: 5 months 3 weeks ago
Joined: 2018-09-27 11:00
DA9062 - nONKEY timing

Dear forum experts,

By reading the DA9062 datasheet (rev 3.5, page 92/96, table 139, see attachment) we're not sure about the timing of the nONKEY input.
Register CONFIG_J [0x10F] contains 2 bits SHUT_DELAY [3:2] and 2 bits KEY_DELAY[1:0] that control nONKEY behavior, but we don't see a mapping to the corresponding durations.
Does the mentioned "durations-matrix" for setting RESET_DURATION (22ms, 100ms, 500ms, 1s) also apply to SHUT_DELAY and KEY_DELAY settings?

Thanks in advance for your support,
Martin

Device: 
ED_Dialog
Offline
Last seen: 1 hour 22 min ago
Staff
Joined: 2017-09-18 11:54
Hello,

Hello,

I have attached a snapshot of table 7.1.1 and table 7.8.3. This table explains the different configurations of nONKEY and the effects of the RESET_DURATION register.

Let me know if you need further clarification.

Kind regards,
Elliott Dexter 

Attachment: 
mmittelberger
Offline
Last seen: 5 months 3 weeks ago
Joined: 2018-09-27 11:00
Hi Elliot,

Hi Elliot,

Thanks for your quick response to our question(s)!

We're aware about the general nONKEY behavior, but we just don't know the durations for SHUT_DELAY and KEY_DELAY settings in CONFIG_J[0x10F] registers.

SHUT_DELAY[3:2] = 00: ?? ms
SHUT_DELAY[3:2] = 01: ?? ms
SHUT_DELAY[3:2] = 10: ?? ms
SHUT_DELAY[3:2] = 11: ?? ms

KEY_DELAY[1:0] = 00: ?? ms
KEY_DELAY[1:0] = 01: ?? ms
KEY_DELAY[1:0] = 10: ?? ms
KEY_DELAY[1:0] = 11: ?? ms

Kind regards,
Martin

ED_Dialog
Offline
Last seen: 1 hour 22 min ago
Staff
Joined: 2017-09-18 11:54
Hello Martin,

Hello Martin,

SHUT_DELAY can be configured to be: 0, 4, 5 and 6 seconds.

KEY_DELAY can be configured to be: 1, 1.5, 2 and 7 seconds. 

These registers can be found in the config tab of the DA9062 GUI. 

Kind regards,
Elliott Dexter 

Attachment: 
mmittelberger
Offline
Last seen: 5 months 3 weeks ago
Joined: 2018-09-27 11:00
Thanks a lot, Elliot, this is

Thanks a lot, Elliot, this is exactly the information we were looking for!

I didn't see the GUI so far (only the datasheet of the chip...), that's why I came up with this question. ;-)
(We're expecting to receive DA9062 eval-kits, by the way...)

Thanks again,
Martin