DA9062 programming

4 posts / 0 new
Last post
andres.aleman
Offline
Last seen: 1 month 5 hours ago
Joined: 2019-08-16 14:50
DA9062 programming

I currently have a PCB that contains the DA9062 chip. The chip is attached to 1x3 header pin on the SDA and SCL pins (and GND) for I2C connection. How should I move forward when it comes to programming the PMIC?

The chip is power-on, I have SmartCanvas installed, but did not purchase the evaluation board.

I am using a USB-GPIO connector provided by TI for another chip (this chip is also using the same header pin connection as the DA9062) that required I2C communication to program.

Using the TI connector, the DA9062 is not being detected. Do I need a Dialog Semiconductor USB-GPIO connector? Any help would be greatly appreciated  

Device: 
ED_Dialog
Offline
Last seen: 1 day 7 hours ago
Staff
Joined: 2017-09-18 11:54
Hello Andres,

Hello Andres,

We have an application note dedicated to in-circuit programming; this application note has a step-by-step guide to programming the part successfully.

Link:

https://support.dialog-semiconductor.com/system/files/pmic_resources/AN-PM-080_In-circuit_programming_DA906x_2v0.pdf

You will have to use either the Dialog ICP board or the DA9061/62 evaluation board to program the parts in system, this is due to the requirements for the correct drivers and software. My advice for production would be to use the ICP board.

Kind regards,

Elliott Dexter

475043
Offline
Last seen: 2 months 1 week ago
Joined: 2019-08-27 03:21
hello

hello
Would you like to let me know what EDA is used for your design documents? such as 232-03-B.pcb and 232-03-B1.sch.
I can not open it with Altium designer.
thx

ED_Dialog
Offline
Last seen: 1 day 7 hours ago
Staff
Joined: 2017-09-18 11:54
Hello,

Hello,

We use the expedition software.

Kind regards,
Elliott