DA9063 Power Commander - Changes are not saved to .ini

3 posts / 0 new
Last post
mattlenz
Offline
Last seen: 3 months 1 week ago
Joined: 2019-03-04 14:17
DA9063 Power Commander - Changes are not saved to .ini

I'm using the DA9063B_3v3 Power Commander Software to create a configuration for the DA9063. I am connected to the DA906x Motherboard, and communication with the DA9063B is working. I can make changes to registers (e.g. changing the VBCORE1_A.VB_A register field to a different voltage) and they take instant effect. However when I save the project to .ini, the changes are reverted.
Under what conditions are register changes applied to the .ini file?

Device: 
ED_Dialog
Online
Last seen: 5 min 16 sec ago
Staff
Joined: 2017-09-18 11:54
Hello Mattlenz,

Hello Mattlenz,

You have to put the GUI into a configuration mode to be able to make changes.

1. Remove connections to Eval board.

2, Open GUI.

3. Load starting point ini file.

4. Go to settings -->  Configuration mode --> Project file values. (the GUI should now turn Gray)/

5. Make changes.

6. Go to settings --> Configuration mode --> "send all pages to temp file" (all pages) or "send page to temp file"(one page at a time, you will also then need to click exit config mode)

7. Save file as a new file.

Let me know if you have any further questions.

 

Kind regards,
Elliott

mattlenz
Offline
Last seen: 3 months 1 week ago
Joined: 2019-03-04 14:17
Now that's what I call

Now that's what I call intuitive and user friendly.
Works though, thanks a lot for the quick response.
Matthias