Issues connecting to device

4 posts / 0 new
Last post
Daylan O'Neil
Offline
Last seen: 1 week 2 days ago
Joined: 2019-08-27 17:12
Issues connecting to device

I'm trying to program some DA9061s with the motherboard 232-01-B and socket board 232-02-A.

Previously I had success in both using power commander mode to test features and the ICP application to program chips, but now I can't do either.  Maybe I'm missing something but it doesn't seem to be able to detect the DA9061.  I've tried fresh parts and ones that have previously been OTP burned, and I've also tested the burned parts work outside of the motherboard.

Is there anything else I can look at? 

Device: 
ED_Dialog
Offline
Last seen: 2 days 7 hours ago
Staff
Joined: 2017-09-18 11:54
Hello Daylan,

Hello Daylan,

Could you send me your .ini file?

Kind regards,
Elliott

Daylan O'Neil
Offline
Last seen: 1 week 2 days ago
Joined: 2019-08-27 17:12
Hi Elliot,

Hi Elliot,

Thanks for your reply, I've gotten a bit further in my troubleshooting and found that I'm getting Write Failures on two ICs that I thought to be new parts which had never been used before.  Two other parts which have previously been burned seem to be working fine, but they have two different ini files which are different than the third which i would like to burn to the new parts.  I don't think the ini file is to blame and I'm not sure which one to send you anyway.

The error I get when I try to Reconnect to Device is [ERROR] Write Failure (bus=i2c, slave=0xb0, address=0x0000, data=0x00).

ED_Dialog
Offline
Last seen: 2 days 7 hours ago
Staff
Joined: 2017-09-18 11:54
Hello Daylan,

Hello Daylan,

Just so i understand, you have two sets of the chips, both with different .ini one set of parts is working and one isnt?

Could you send me the .ini files for both?

Kind regards,
Elliott