How to use Smartsnippets to burn flash of EVKT-B?

3 posts / 0 new
Last post
Alex Luo
Offline
Last seen: 2 years 10 months ago
Expert
Joined: 2014-02-28 19:16
How to use Smartsnippets to burn flash of EVKT-B?

Hello Dialog,

I tried to use Smartsnippets to burn the hex file (compiled by Keil), but it can't...
After checking the schematics of DA14580EVKT-B, it seems that its flash can be burnt by Smartsnippets. If it's not right, please let me know how to do it.

I can download the hex file into DA14580, and works well. But can't burn the flash. I tried all modes, only UART mode works and the code can be downloaded into the cheap. If using UART/SPI, and select Flish, all of the buttons inactive. For J4, I tried both UART and SPI, doesn't work either (since the chip should connect to SPI, but for connecting UART, SPI can't be used.).

please advise the setup.

Thanks,
Alex

JE_Dialog
Offline
Last seen: 1 year 1 month ago
Staff
Joined: 2013-12-05 14:02
**** Alex, Smart Snippets 3.5

Hell Alex, Smart Snippets 3.5 supports writing to flash with BASIC development kit. Can you check which version of Smart Snippets you are using ?  You should also be on SDK 3.0.4 or later.

Thanks & BR

JE_Dialog.

Alex Luo
Offline
Last seen: 2 years 10 months ago
Expert
Joined: 2014-02-28 19:16
Hi JE,

Hi JE,

I will update smartsnippet 3.5, and I used is the version 3.4 win32. The SDK I used is 3.0.4.
The EVK Basic version is 078_30_B, on the back witg QR code:2214_00098 480054415.
Also please let me know the process of burnning flash on this board and jumper setup on the board.

Thanks,
Alex