OTP program in mass production, Vpp enable pin?

3 posts / 0 new
Last post
Jda
Offline
Last seen: 3 years 1 month ago
Joined: 2015-04-24 10:43
OTP program in mass production, Vpp enable pin?

Hi,

My colleague who is developing hardware and I were finding out what we need in order to program the OTP in mass production. We're going to use a Murata module containing the DA14580 and external SPI flash. The OTP will contain the secondary bootloader.

Murata reference designs shows that P0_7 is used to enable Vpp via an external transistor when programming the OTP. They also say that any other GPIO-pin may be used in stead of P0_7.

However, we cannot find this automatic Vpp-control in Dialog's "AN-B-020_v1.3_End product testing and programming guidelines", it says the PC should enable Cpp (via an interface board).
Also, the SmartSnippets software doesn't have a setting for this pin? I didn't perform the actual OTP programming, only checked the GUI, so maybe the pin can be set later on in the procedure.

Does anybody know where we can find details of this feature?
And do we need to use it or is it preferred to let the PC enable Vpp as stated in AN-B-020 ?

BR,
Jesper

Device: 
summer20100514
Offline
Last seen: 3 years 12 months ago
Guru
Joined: 2014-12-30 05:01
You can set the vpp enable

You can set the vpp enable pin in Board Setup tab which is the first tab of SmartSnippets. But as far as I am concerned, you can enable and disable vpp manually, and what you should remember is that

6.8V can only be applied to VPP after VBAT3V is supplied and 6.8v must be
removed from VPP before the supply to VBAT3V is removed. Otherwise the chip could be
damaged.The 6.8V supply must be applied without ringing. The overshoot could also cause
damage.

Jda
Offline
Last seen: 3 years 1 month ago
Joined: 2015-04-24 10:43
Thanks! This solves our

Thanks! This solves our questions :)

BR,
Jesper

Topic locked