1 post / 0 new
Last seen: 2 months 1 week ago
Joined: 2015-02-23 14:16
PAN1740 UART Baud rate


I want to use the PAN1740 module connected to a microcontroller over UART. In the datasheet of the PAN1740 is described the default UART with RTS P0.2, CTS P0.3, RX P0.5 and TX P0.4.
In AN-B-001 is described the loaction for UART with Baud rate 115,2kbits/s but only the RX (P0.2) and TX (P0.3) location.
Where must I connect the RTS and CTS pins at the PAN1740 in my schematic for using this Baud rate?
Is flow control supported for this Baud rate?
Is there a example schematic you can give to me?

Thank You.

Best Regards