2 posts / 0 new
Last post
R.Gantner
Offline
Last seen: 2 months 2 weeks ago
Joined: 2014-01-18 13:57
Ports for Onboard OTP programming

On the DevKit Motherboard the USB- UART is connected to this Ports:
UTX - P0_4
URX - P0_5
UCTS - P0_2
URTS - P0_3

Which Port must be connected for an Onboard serial OTP programming via Smartsnippet ?
Is there any additional Port necessary (for example to switch the VPP P1_2) for the programming ?

gl_dialog (not verified)
Dear Sir GANTNER,

Dear Sir GANTNER,

Thank you for your interest.

1. You can select the port you want from the Board Setup tab on the left side of smartsnippet.
(either P0_0 and P0_1 or P0_2 and P0_3 or P0_4 and P0_5 or P0_6 and P0_7).

2. No additionnal port are necessary for the programming.

Hope this helps,

Best regards,

DIALOG SUPPORT TEAM.